B&B Electronics EIR510 Series Merkblatt
EIR510 Series-5107qsg
International Headquarters: 707 Dayton Road PO Box 1040 Ottawa, IL 61350 USA
815-433-5100 Fax 433-5104
www.bb-elec.com
orders@bb-elec.com
support@bb-elec.com
European Headquarters: Westlink Commercial Park Oranmore Co. Galway Ireland
+353 91 792444 Fax +353 91 792445
www.bb-europe
.com orders@bb-europe.com support@bb-europe.com
Items Included
1
2
Default Settings
3
LED Chart
4
Hardware Installation
Log into the Switch
5
o
Ethernet Switch
o
Console Cable (RS-232 RJ-45 to DB-9)
o
CD with Support Manual
o
This Quick Start Guide
o
Panel Mount Bracket
o
IP Address: 192.168.16.1
o
Subnet Mask: 255.255.255.0
o
Gateway: 192.168.16.254
o
User Name: root, Password: root
LED Status
Meaning
Green
The Switch is powered on
PWR
Off
The Switch is powered off
Green
Power Source 1 is available
PWR1
Off
Power Source 1 is unavailable
Green
Power Source 2 is available
PWR2
Off
Power source 2 is unavailable
Orange
A power or port failure has occurred
Fault
Off Normal
Operation
Green
The Switch is the master of a redundant
ring (X-Ring)
R.M
Off
The Switch is not the master of a
redundant ring.
redundant ring.
Green
The port is linked
Blinking
Data is being transmitted or received
LINK/ACT
(P9/P10)
(P9/P10)
Off
Not connected to the network
Top
Green
Connected to the network
Top
Blinking
Transmitting or receiving
Top
Off
Not connected to the network
Bottom Orange Operating
at
full-duplex
Bottom Blinking Collision
P1-8
Bottom Off
Half-duplex or not connected
o
Record the switch’s MAC Address in the space
provided. Provide the MAC Address to your Network
Administrator. The Network Administrator will
provide an IP Address, Subnet Mask and Gateway.
provided. Provide the MAC Address to your Network
Administrator. The Network Administrator will
provide an IP Address, Subnet Mask and Gateway.
o
Select a mounting location and install with the attached
DIN rail clip or included panel mount kit.
DIN rail clip or included panel mount kit.
o
Connect power to the switch
o
24 to 48 VDC
o
Redundant inputs are available with fault
contacts.
contacts.
o
These instructions are for Web based management.
Refer to the User’s Manual for instructions concerning
console management.
Refer to the User’s Manual for instructions concerning
console management.
o
Connect a stand alone PC to a port on the switch.
Change the PC’s network IP Address to allow it to
connect to the switch (ex: 192.168.16.2). Use the
default subnet mask and gateway.
Change the PC’s network IP Address to allow it to
connect to the switch (ex: 192.168.16.2). Use the
default subnet mask and gateway.
o
Launch the PC’s web browser and navigate to the
switch by typing the switch’s IP address in the browser
address window.
switch by typing the switch’s IP address in the browser
address window.
o
Navigate the web page by expanding the folders on the
left side of the web page.
left side of the web page.
Quick Start Guide
Elinx Managed Ethernet Switch
EIR510 Series