B&B Electronics PCMCIA 232PCC2 Benutzerhandbuch

4 

Documentation Number 232PCC23799 Manual 

 

In order to use the 232PCC2 Client Driver, the system must be 

configured with Card and Socket Services software.  
 
IMPORTANT: 
 

Some versions of Card and Socket Services dated before 1993 

do not support general purpose I/O cards.  If after careful installation 
of the Client Driver the 232PCC2 does not configure or operate 
properly, an updated version of Card and Socket Services may be 
required.  

The following procedure is used to install the 232PCC2 Client Driver: 

•

  Copy the file DSP100CL.SYS from the 232PCC2 

distribution diskette onto the system's hard drive. 

•

  Using an ASCII text editor, open the system's 

CONFIG.SYS file located in the root directory of the 
boot drive. 

•

  Locate the line(s) in the CONFIG.SYS file where the 

Card and Socket Services software is installed. 

•

  AFTER the line(s) installing the Card and Socket 

Services software, add the following line to the 
CONFIG.SYS 

file: 

   

 

 

 

 

 

 

 

 DEVICE 

= 

drive:\path\DSP100CL.SYS options 

where options are the 232PCC2 Client Driver command 
line options discussed on the following pages. 

•

  Save the CONFIG.SYS file and exit the text editor. 

•

  Insert the 232PCC2 into one of the system's PCMCIA 

slots. 

NOTE:  Since the 232PCC2 Client Driver supports "Hot 
Swapping", it is not necessary to have the 232PCC2 
installed when booting the system.  By inserting the card 
before booting, however, the Client Driver will report the 
adapter configuration during the boot process thereby 
verifying the changes made to the CONFIG.SYS.