BMW K 1100 LT/RS Benutzerhandbuch
23.24
Installing transmission cover
•
Knock out cap (arrow) from the inside using a
drift.
drift.
•
Heat up transmission cover to 100°C.
•
Parting surface at housing and cover must be
clean and free of grease.
clean and free of grease.
•
Thinly coat one of the two parting surfaces with
Loctite 574 or with Three-Bond 1209.
Loctite 574 or with Three-Bond 1209.
•
With the aid of a drift or screwdriver, press back
locking lever in direction shown by arrow.
locking lever in direction shown by arrow.
•
Carefully fit cover on the housing.
•
Screw in screws holding transmission cover and
firmly tighten.
firmly tighten.
X
Tightening torque:
Retaining screws for cover
............................. 9 Nm
•
Thinly coat end cap (arrow) with
Three-Bond 1209 and knock in with drift by
8 mm (0.31496 in).
Three-Bond 1209 and knock in with drift by
8 mm (0.31496 in).
•
Fit idle lock (ball and spring) in idle position.
•
Screw in screw for idle lock coated with
Loctite 243.
Loctite 243.
X
Tightening torque:
Screw for idle lock
........................................ 13 Nm
LT230420
LT230370
LT230380