Billion Electric Company BIPAC-2AB 2.0 Benutzerhandbuch

 

Make sure that you have all you need to connect the BIPAC-2AB 2.0 ISDN a/b 
adaptor.  You should have the following: 

1.  At least one analog telephone (or other analog device) 

2.  A power outlet that supplies 220 ~ 240 volts AC 

3.  An ISDN basic rate S

0

 interface released by PTT (Post, Telephone 

and Telegraph administration) 

Please refer to the following instructions and figures for installation procedures: 

1.  Connect one or two analog telephones (or other analog devices) to the 

RJ-11 jacks labeled “a/b 1” or “a/b 2” on the back of the BIPAC-2AB 
2.0.  Refer to Figure 2. 

2.  Connect your ISDN line to the RJ-45 jack labeled “ISDN S

0

” on the 

back of the BIPAC-2AB 2.0.  Refer to Figure 2. 

3.  Plug the power adaptor into the power outlet.  The POWER LED will 

illuminate on the front panel.