Bil-Jax Personal Lift ESP 19 Benutzerhandbuch

7.  When joystick is moved, lift 

vehicle will not travel. (cont) 

f. 

Motor controller, motor controller 
output wiring, or transaxle drive mo-
tor faulty. 
 
 
 
 
 

g.   Transaxle drive train damaged. 

f. 

Check for output voltage to drive 
motor when joystick is engaged. If 
drive voltage is not present at motor 
controller, replace motor controller. If 
drive voltage does not reach drive 
motor, repair wire break. If drive volt-
age is present at drive motor, replace 
drive motor.  

g.   If transaxle drive motor runs, inspect 

drive train components for damage. 
Repair or replace transaxle gearhouse, 
if damaged. 

8.  When steering thumb switch 

is pressed, steering wheels 
do not swivel. 

a.  Wheels turned to steering limit. 

b.  10 Amp Motors fuse burned out on 

main controller board. 

c.  Internal steering actuator fuse. 

d.  Thumb switch or thumb switch wiring 

faulty. 
 
 
 

e.  Actuator or actuator wiring faulty. 

 
 
 
 

f. 

 Steering linkage failed. 
 

g.  Main controller faulty. 

a.  Turn wheels in opposite direction. 

b.  Replace 10 Amp Motors fuse. 

 

c.  Replace steering actuator fuse. 

d.  Check for lighted steering LED when 

thumb switch is engaged. If LED does 
not light, signal is not reaching main 
controller; repair wire break or re-
place faulty joystick. 

e.  Check actuator wiring for operating 

voltage. If voltage is present, replace 
faulty actuator. If voltage is not pre-
sent, check actuator wiring for conti-
nuity; repair wire breaks.  

f. 

 Check steering linkage for damage; 
replace damaged parts. 

g.  Contact Bil-Jax for assistance. 

9.    When BATTERY ON/OFF 

switch is turned ON, hydrau-
lic pump starts up. 

  a.    Motor start relay failure; relay con-

tacts fused shut. 

a.  Replace motor start relay.