Benq W5000 Benutzerhandbuch

  19

  Using the projector

Eng
lish

Using the projector

Preparations
1.

Plug in and turn all of the connected equipment on.

2.

If not already in, plug the supplied power cable into the AC inlet on the 
rear of the projector and turn on the power switch. 

3.

Plug the power cable into a wall socket and turn the wall switch on.

Turning the projector on

Follow the steps below.
1.

Make sure the Power light is orange after power has been applied and 
the main AC power switch is turned on.

2.

Press and hold POWER (

) on the projector or remote control to 

turn the projector on.

3.

The fans will start operating, and a start-up image displays on the 
screen for a few seconds while it warms up.

4.

If you are prompted for a password, press the arrow keys to enter a six 
digit password. See 

"Utilizing the password function" on page 21

 for 

details.

5.

"Source Searching..." will be displayed on the screen before the 
projector identifies the input signal. This message will remain on the 
screen until a valid signal is detected. See 

"Selecting an input source" on 

page 19

 for details.

6.

If the horizontal frequency of the input signal exceeds the range of the 
projector, the message "Out of Range" will be displayed on the screen. 
This message will remain on-screen until you change the input signal to 
an appropriate source. 

Selecting an input source

The projector can be connected to multiple equipment at the same time. 
When the projector is first turned on, it will attempt to reconnect with the 
input source which was in use when the projector was last shut down.
To select the video source:

•

Using the remote control or projector

Press one of the Source buttons on the remote control, or press SOURCE on 
the projector repeatedly until your desired signal is selected. To switch between 
HDMI 1 and HDMI 2, press HDMI 1.2 again.

•

Using  the  OSD  menu

1.

Press MENU and then press  /  until the System Setup menu is 
highlighted.

2.

Press   to highlight Input Source and press ENTER. The source 
selection bar displays.

3.

Press  /  repeatedly until your desired signal is selected and press 
ENTER.
Once detected, the selected source information will display on the screen 
for seconds. If there is multiple equipment connected to the projector, 
you can go back to the source selection bar again to search for other 
signals.

•

If you want the projector to automatically search for the signals, select 
On in the System Setup > Auto Source Search menu.

•

If you want to use the PIP function, see 

"Displaying more than one image 

source simultaneously" on page 32

 for details.

W20000-en.book  Page 19  Monday, October 22, 2007  3:35 PM