Benq W10000/W9000 Benutzerhandbuch

  19

  Using the projector

English

Using the projector

Preparations

1. Plug in and turn all of the connected equipment on.
2. If not already in, plug the supplied power cable into the AC inlet on the 

rear of the projector and turn on the power switch. 

3. Plug the power cable into a wall socket and turn the wall switch on.

Turning the projector on

Follow the steps below.

1. Make sure the Power light is orange after power has been applied and the 

main AC power switch is turned on. 

2. Press and hold the POWER button on the projector or remote control to 

turn the projector on.

3. The fans will be start operating, and a start-up image displays on the screen 

for a few seconds whilst it warms up. 

4. "Searching…." will be displayed on the screen before the projector identifies the input signal. This message 

will remain on the screen until a valid signal is detected. 

5. If the horizontal frequency of the input signal exceeds the range of the projector, the message "Unsupported 

timing" will be displayed on the screen. This message will remain on-screen until you change the input signal 
to an appropriate source. 

Selecting an input video source

The projector can be connected to multiple equipment at the same time. To 
select an individual input signal, press one of the Source buttons on the remote 
control, or to sequentially cycle through all possible sources, press the SOURCE/
ENTER button on the projector.

• When the projector is first turned on, it will attempt to reconnect with the 

input source which was in use when the projector was last shut down. 

• If you want to use the PIP or POP function. 

See page 22

 for details.

Adjusting the projected image 

Adjusting the projection angle 

There are four adjuster feet on the bottom of the projector. These can 
be used if necessary to change the projection angle. Screw the feet in or 
out as appropriate to aim and level the projection angle. 

W10000-en.book  Page 19  Thursday, October 19, 2006  1:45 PM