Benq MP620 Benutzerhandbuch
Operation
25
Operation
Start up
1.
Plug the power cord into the projector and into
a wall socket. Turn on the wall socket switch
(where fitted). Check that the Power indicator
on the projector lights orange after power has
been applied.
a wall socket. Turn on the wall socket switch
(where fitted). Check that the Power indicator
on the projector lights orange after power has
been applied.
2.
Remove the lens cap. If it is left on, it could
become deformed due to the heat produced by
the projection lamp.
become deformed due to the heat produced by
the projection lamp.
3.
Press and hold (for 2 seconds) the Power
button on the remote control or projector to
start the unit. The Power indicator light flashes
green and stays green when the unit is on.
The start up procedure takes about 30 seconds
after pressing Power. In the later stage of start
up, a default BenQ logo is projected.
(If necessary) Rotate the focus ring to adjust
the image clearness.
button on the remote control or projector to
start the unit. The Power indicator light flashes
green and stays green when the unit is on.
The start up procedure takes about 30 seconds
after pressing Power. In the later stage of start
up, a default BenQ logo is projected.
(If necessary) Rotate the focus ring to adjust
the image clearness.
If the projector is still hot from previous activity, it will
run the cooling fan for approximately 90 seconds before energising the lamp.
run the cooling fan for approximately 90 seconds before energising the lamp.
4.
If you are prompted for a password, press the arrow buttons to select the four
password digits, then press Auto. For information about the password function, refer
to
password digits, then press Auto. For information about the password function, refer
to
.
5.
Switch all of the connected equipment on.
6.
The projector will start to search for input signals. The current input source being
scanned displays at the center of the screen. The search will continue until an input
source signal is detected.
You can also press Source on the projector or remote control to select your desired
input signal. For more information, please refer to
scanned displays at the center of the screen. The search will continue until an input
source signal is detected.
You can also press Source on the projector or remote control to select your desired
input signal. For more information, please refer to
If the frequency/ resolution of the input signal exceeds the projector’s operating range, you
will see the message “Out of Range” displayed on a blank screen.
will see the message “Out of Range” displayed on a blank screen.
Utilizing the password function
For security purposes and to help prevent unauthorized use, the projector includes an
option for setting up password security. The password can be set through the on-screen
menu. For details of the on-screen menu operation, please refer to
option for setting up password security. The password can be set through the on-screen
menu. For details of the on-screen menu operation, please refer to
for information.
WARNING: You will be inconvenienced if you activate the password functionality and
subsequently forget the password. Print out this manual (if necessary) and write the password
you used in this manual, and keep the manual in a safe place for later recall.
subsequently forget the password. Print out this manual (if necessary) and write the password
you used in this manual, and keep the manual in a safe place for later recall.