Behringer Europower EP2000 Broschüre

PA Amplifiers

The EP2000 and EP4000 represent  

everything musicians love about our 
popular EP1500/EP2500—excellent 
sound quality, road-worthy toughness 
and reliability, low-noise operation 
and incredible power. With 2,000 and 
4,000-Watts respectively, the EP2000 
and EP4000 amplifiers are perfect for 
medium-sized club gigs, mobile PA 
systems, church services or public spaces.

The über-simple front panel controls 

of these amps give you all of your sound’s 
vital signs at a glance. After flipping 
the MAIN switch, the POWER LED will 
light when the amp is ready for action. 
Both channels have independent gain 
dials as well as clip LEDs that indicate 
when the signal is distorted and you need 
to reduce the gain. There are also SIGNAL 
LEDs that light up when a signal is present 
at the input.

A panel of switches found on the 

back panel offers an array of cool 
options to apply to both channels of 
the EP2000 and EP4000. The Clip Limiter 
lets you get even more out of the 

amplifier without overdriving either it 
or your speaker system. Built-in circuitry 
automatically senses when the EP2000 or 
EP4000 is being overdriven into “clipping” 
and then momentarily reduces the input 
level to avoid clipping distortion. This all 
happens in a few thousandths of a second, 
so it’s an inaudible way of avoiding audible 
clipping distortion. Of course, you can turn 
the Limiter off if you’re feeling lucky.

Ultra-low frequency sounds 

(infrasonics) are caused by rickety stage 
vibrations, mic thumps and wind noise. 
While technically inaudible, they can 
cause a huge drain on amp power, 
potential damage to your speakers 
and a sludgy sound in the audible 
bass ranges. Both EP models feature a 
defeatable Low Cut Filter that chops 
off unwanted frequencies below 
50Hz or 30Hz (depending on your PA 
system’s capabilities).

The same panel contains the switches 

that allow you to put these amps to 
work in either stereo or bridge (mono) 
mode. Both the EP2000 and EP4000 can 
be linked to additional power amps by 
switching into parallel mode. 

EP4000: 2 x 2,000 Watts into 2 Ohms; 
2 x 1,400 Watts into 4 Ohms; 
4,000 Watts into 4 Ohms 
(bridge mode)
EP2000: 2 x 1,000 Watts into 2 Ohms; 
2 x 750 Watts into 4 Ohms; 
2,000 Watts into 4 Ohms 
(bridge mode)
Precise Power, Signal and Clip LEDs 
to monitor performance
XLR and ¼" TRS input connectors for 
compatibility with any source
Professional speaker connectors and 
“touch-proof” binding posts support 
most speaker wiring systems
Selectable low-frequency filters  
(30 Hz or 50 Hz) remove distracting 
infra-sound frequencies
Independent limiters per channel 
offer reliable protection against 
overload and distortion
High-current toroidal transformer for 
ultra-high transient response and 
absolute reliability
Ultra-reliable Toshiba/Fairchild  
power transistors
Independent DC and thermal 
overload protection on each channel 
automatically protects amplifier 
and speakers without shutting 
down the show

“Back-to-front” ventilation 

system including air filter for 
reliable operation

“Built-like-a-tank,” impact-resistant, 

all-steel 2U rackmount chassis
High-quality components and 
exceptionally rugged construction 
ensure long life
Conceived and designed by 
BEHRINGER Germany