Baumatic BCG520BL Benutzerhandbuch
37
o
With the control panel removed, refit the oven and gas
thermostat control knobs. Ignite each burner separately and set
the control knob to the minimum position.
thermostat control knobs. Ignite each burner separately and set
the control knob to the minimum position.
o
Using a suitable screwdriver, turn the screw clockwise to
decrease the flow of gas and make the flame smaller. Turn the
screw anti-clockwise to increase the flow of gas and make the
flamer bigger.
decrease the flow of gas and make the flame smaller. Turn the
screw anti-clockwise to increase the flow of gas and make the
flamer bigger.
o
To establish the correct adjustment, the flame should be
approximately 3 - 4 mm in length. For Butane / Propane gas, the
adjusting screw must be tightly screwed in.
approximately 3 - 4 mm in length. For Butane / Propane gas, the
adjusting screw must be tightly screwed in.
o
Turn the control knob to maximum and then back to minimum
two or three times to make sure that the flame does not go out
when the control knob is set to minimum.
two or three times to make sure that the flame does not go out
when the control knob is set to minimum.
o
If the flame does go out, repeat the procedure again.
o
Remove the control knobs for the oven and grill and refit the
control panel and hob top taking care to ensure they are fitted
correctly.
control panel and hob top taking care to ensure they are fitted
correctly.
o
Replace all the control knobs.
o
Your cooker should now be adjusted correctly to work on LPG
gas.
gas.