Barco Projector 26-0313000-00 Benutzerhandbuch

Controller Sections

The figures below illustrate the 

Group Control Section on each Controller.  The sections 

are essentially identical, except that the Controller SC has fewer group buttons.

Figure 4-21.  Group Control Section, Controller SC

Figure 4-22.  Group Control Section, Controller LC

A single “group” button can be programmed to represent one or more destinations.  This 
feature simplifies the method by which you activate destinations.  Descriptions of each 
button are provided below.  

Group Buttons — four groups are available on the Controller SC; eight on the Controller 
LC.  Any combination of 

Group buttons can be enabled, but all group selections (whether 

individual or multiple) are mutually exclusive.    

Press a numbered 

Group button by itself to enable the assigned destination(s) 

and toggle all other groups (and destinations) off.  When pressed, the assigned 
destination buttons immediately light on the 

Destination Bus.  

Press two or more 

Group buttons simultaneously to enable multiple groups of 

destinations (e.g., Groups 

1, 3 and 4), and toggle all other active groups (and 

destinations) off.  

All — (Controller LC only) 

Press 

All to activate (enable) all assigned groups of destinations.  

On the Controller SC, you must simultaneously press all assigned 

Group buttons 

to perform the “all enable” function. 

Clear — (Controller LC only)

Press 

Clear + a selected Group button to clear that one group only.

Press 

Clear + ALL to clear all active groups. 

On the Controller SC, there are two ways to clear a group:

Press the group(s) that you wish to remain enabled (which will, in turn, 
clear the other un-selected groups).

Press and hold the 

Clear button (on the Destination Bus), then press 

the button(s) for the destination(s) that you wish to clear.