Barco Projector 26-0313000-00 Benutzerhandbuch

ID Setup and Remote Enable

Encore system setup:  Step 1.

In this procedure, you will set up individual Encore Video Processor IDs.  If ScreenPRO-II, 
PresentationPRO-II and/or ImagePRO units are used as destinations, you will also set their 
IDs and enable remote control.  Each unit in your system must have a unique ID.

„

Use the following steps to set up IDs and remote control: 

Power up your Encore Controller, and allow it to fully boot up.  This is the system’s 
DHCP server.

To set Encore Video Processor IDs:

Using the Unit ID Selector on the rear of each Processor, set the 
desired ID.  Logical IDs 1 - 16 are available.

If you elect to use “extended” IDs 17 - 32, use the Video Processors ID 
Definition Menu

 to redefine the IDs.  In Chapter 5, refer to the “

” section on page 202 for details.  

Repeat step 3 for all other Video Processors in your system.

Power up all Encore Video Processors, ScreenPRO-II units, PresentationPRO-II 
units and ImagePRO units in your system.  This sequence enables the Encore 
Controller to “serve” IP addresses to the Processors and other peripherals.

To set ScreenPRO-II and PresentationPRO-II IDs and enable remote control:

Ensure that the ScreenPRO-II and PresentationPRO-II units are 
connected to the same Ethernet Switch as the Video Processor(s).

Press {REMOTE CONTROL} on the Home Menu to access the Remote 
Control Menu

.

Scroll to the Unit ID line, and select a unique ID.  The ID range is 1 to 32.

Scroll to the Remote Control/DHCP line, and enable remote control.  

Press {SAVE} to save the system state in non-volatile memory — so that 
it will return to it should power need to be cycled.

Repeat step 4 for all other ScreenPRO-II and PresentationPRO-II units in 
your system.

To set ImagePRO IDs and enable remote control:

Ensure that the ImagePRO units are connected to the same Ethernet 
Switch as the Video Processor(s).

1

If you are setting up a “stack” configuration, the ID of the 
bottom stack Video Processor must always be lower than the 
ID of the top stack Processor.

When remote control is on, the {HOME} buttons disappears, 
the ScreenPRO-II (or PresentationPRO-II) front panel is 
disabled, and the unit’s IP address is dynamically assigned.  
All control now originates from Encore’s console.