Barco Projector 26-0313000-00 Benutzerhandbuch

Input Setup

Encore system setup:  Step 17 

S

 — Ensure that you are familiar with the Input Menu.  In 

Chapter 5, refer to the “

” section on page 148.

This procedure provides steps for setting up the system’s inputs, for single screen, wide 
screen and “stack” destinations.  The following topics are provided:

„

Use the following “quick start” method to set up inputs.   

On the Destination Bus, select the destination whose inputs you want to set up.

On the Controller, select a layer button in the Layer Control Section.

In the Layer Functions Section, press Source Preview.  This action isolates the 
source within the PIP, displays a gray background, turns off borders and shadows, 
and displays the Input Menu.  

On the Source Selection Bus, select the source that you want to set up.   

Press 

{

}

to perform the optimum image setup.

Press 

{

}

to save the new input configuration in memory.

Repeat from step 4 for the next source.

(For non-stack configurations only)  When all sources have been set up for the 
selected destination, press Source Preview to restore the previous setup.    

Repeat from step 1 for the next destination — only if required.  Refer to the “

” section on page 296 for details.    

„

Use the following “comprehensive” method to set up inputs.   

On the Destination Bus, select the destination whose inputs you want to set up.

On the Controller, select a layer button in the Layer Control Section.

In the Layer Functions Section, press Source Preview.  

17

The Source Preview function is not available with “stack” 
configurations.  In this situation, use the PIP Adjustment 
Menu 

to turn off borders and shadows, and then press INPUT 

in the System Keypad.