Barco Projector 26-0313000-00 Benutzerhandbuch

Working with Destinations

Destinations can be configured as single screens (projectors), multiple screens (in wide 
screen applications), single or wide screen "stack" configurations, ScreenPRO-II systems, 
auxiliary router outputs, ImagePRO systems and PresentationPRO-II systems.    

During system setup, multiple destinations can be configured:

On the Controller SC, 6 destinations are available. 

On the Controller LC, 32 destinations are available.

In Chapter 6, refer to the “

" section on page 277 and the “

" section on page 288 for complete destination setup instructions.

The following topics are discussed in this section:

„

Use the following steps to activate and deactivate destinations: 

 — press the desired button on the Destination Bus to route signals to 

that destination (e.g., single or multiple projectors, Aux, ScreenPRO-II, etc.).  The 
button lights when activated.  Any combination of destination buttons can be 
enabled sequentially — the buttons are not mutually exclusive.

 — press Clear + the desired button on the Destination Bus to 

remove the selected destination from the output routing.  Any combination of 
destination buttons can be cleared sequentially.  

 — If multiple destinations are active, press and hold one destination 

button to momentarily isolate that destination for modification.  Release to return 
to the “group” selection.

„

Use the following steps to clear destinations:

To clear a single destination, press Clear + the desired button on the Destination 
Bus

 to remove it from the output routing.  

(Controller LC only)  To clear all destinations, press Clear + All.

“Groups” can also be used to activate and deactivate single 
or multiple destinations with one-button ease.  Refer to the 
“

" section on page 312 for details.