Barco Projector 26-0313000-00 Benutzerhandbuch

Working with Layers

The following topics are discussed in this section:

The following sources are available: 

On the Controller SC, 24 sources are available. 

On the Controller LC, 64 sources are available.

„

Use the following steps to switch sources into a PIP or a Key:

Select a destination that is not an Aux destination.

Select a layer button (in the Layer Control Section).  Ensure that it is blinking.

Select PIP or Key as desired.

Press the desired button on the Source Selection Bus to assign that source to 
the PIP or Key.

On the Controller SC, sources 1 - 12 are accessed directly.  Press and 
light the Shift button to access sources 13 - 24.

On the Controller LC, sources 1 - 32 are accessed directly.  Press and 
light the Shift button to access sources 33 - 64.

The source button blinks to indicate that it is selected and active for modification.  

Please note the following points regarding sources:

The Shift button on the Source Selection Bus is a toggle.  It stays lit until 
pressed again.

When the Red LED above a source button is lit, the source is on Program.

When a source button is lit solid, the source is on Preview — but it is not active for 
manipulation.  Only blinking source buttons are active for modification.

Multiple sources can appear on Program and Preview simultaneously, but only 
one button can be blinking and active for modification on Preview.