Barco Projector 26-0313000-00 Benutzerhandbuch

Working with Transitions

This section provides instructions for performing a variety of transitions.  The following 
topics are discussed:

Cuts can be performed on both single screen and widescreen destinations.  

„

Use the following steps to perform a Cut:

Set up the desired “look” in Preview.  

In the Transition Section, press CUT to instantly cut the setup to Program.

Cuts can also be performed directly on Program in the following three modes:

 is enabled.  Refer to the "

" section on page 328 for details.

 Mode is enabled.  Refer to the "

" section on page 340 for details.

 Mode is enabled.  Refer to the "

" section on page 340 for details.

A Mix (or Dissolve) can be performed on both single screen and widescreen destinations.  

„

Use the following steps to perform a Mix:

Set up the desired “look” in Preview.  

Preset the mode and transition rate:  

In the System Keypad, press EFFECTS to display the Effects Menu.

Adjust the Transition Rate field, in 0.1 second increments.

In the Transition Type field, select Mix.

In the Transition Section, press AUTO TRANS to dissolve the setup to Program.