Barco Projector 26-0313000-00 Benutzerhandbuch
360
Encore Presentation System • User’s Guide • Rev 04
7. Operations
Working with Frame Grabs
•
Press YES to save the frame. All front panel controls will be
locked for up to three minutes.
locked for up to three minutes.
•
Press NO to cancel the procedure.
~
In "ES" systems, the Extended Frame Save Menu appears.
•
In the Saved Location field, select a memory location (1 - 100).
•
(Optional) In the New Name field, type a new name. Ensure
that a PS/2 keyboard is properly connected to the Controller’s
Keyboard
that a PS/2 keyboard is properly connected to the Controller’s
Keyboard
port.
•
Press {SAVE} to save the selected frame. All front panel
controls will be locked for up to three minutes.
controls will be locked for up to three minutes.
4.
Repeat the procedure to save additional frames.
k~ãáåÖ=~=p~îÉÇ=cê~ãÉ
Use the following steps to name (or rename) a saved frame.
1.
Ensure that the frame you wish to name has either been captured, or saved in
permanent memory.
permanent memory.
2.
Ensure that a (customer supplied) PS/2 keyboard is connected to the Controller’s
Keyboard
Keyboard
connector.
3.
On the Frame Grab Menu, press {NAME} to display the Frame Grab Name
Menu
Menu
.
4.
On the Saved Location line, select the frame that you wish to name.
5.
Using the keyboard, enter the desired name. As you type, characters will appear
in the menu’s New Name field.
in the menu’s New Name field.
6.
Press Enter (on the PS/2 keyboard) to save the new name. Once saved, the
system "attaches" the name to the frame in permanent memory.
system "attaches" the name to the frame in permanent memory.
7.
Repeat the procedure to name additional frames.
Note
Remember that you can always overwrite a frame in
permanent memory.
permanent memory.
Note
If the frame has only been captured, you can use the "Save"
procedure to both save and name the frame simultaneously.
Refer to the "
procedure to both save and name the frame simultaneously.
Refer to the "
section on page 359 for details.
Note
If you are using a ScreenPRO-II destination, ensure that the
Tally
Tally
option is physically installed.