Barco Projector 26-0313000-00 Benutzerhandbuch
Encore Presentation System • User’s Guide • Rev 04
59
2. Hardware Orientation
Controller Rear Panels
3) MultiMedia
Card
Slot
One MultiMedia Card Slot is provided for a Flash Memory Card connection to the
Controller. The flash card enables you to store and recall system configurations,
and transfer them between Controllers as required. In Chapter 5, refer to the
“
Controller. The flash card enables you to store and recall system configurations,
and transfer them between Controllers as required. In Chapter 5, refer to the
“
” section on page 196 for details on backup and restore.
4) Ethernet
Port
One RJ-45 connector is provided for 10/100BaseT Ethernet communications with
the Encore Processor. The Ethernet connector is compatible with:
the Encore Processor. The Ethernet connector is compatible with:
~
Standard RJ-45 Ethernet cables
~
Neutrik EtherCon
®
series cables
For multiple connections in an Encore system, an Ethernet switch on an isolated
network is recommended. In Appendix A, refer to the “
network is recommended. In Appendix A, refer to the “
”
section on page 372 for pinout details.
5) Ext
Comm
One 9-pin D connector is provided for RS-232 serial communications with a serial
device, such as a router. In Appendix A, refer to the “
device, such as a router. In Appendix A, refer to the “
” section
on page 373 for pinout details.
6) Console
Port
One 9-pin D connector is provided for RS-232 serial communications with an
ASCII terminal for command-line control of the Encore system. In Appendix A,
refer to the “
ASCII terminal for command-line control of the Encore system. In Appendix A,
refer to the “
” section on page 373 for pinout details.
7) Tally
Connector
One 25-pin D connector is provided for issuing tally “relay closure” commands to
external devices such as cameras. Eight tally circuits are provided. In
Appendix A, refer to the “
external devices such as cameras. Eight tally circuits are provided. In
Appendix A, refer to the “
” section on page 374 for pinout details.
8) AC
Power
Use the AC Power connector to connect the Controller to your facility’s AC power
source. The integral switch turns the Controller on and off.
source. The integral switch turns the Controller on and off.