Barco Projector 26-0313000-00 Benutzerhandbuch

Seite von 432
62
Encore Presentation System  •  User’s Guide  •  Rev 04
3.  Hardware Installation
Safety Precautions
p~ÑÉíó=mêÉÅ~ìíáçåë=
For all Encore Presentation System installation procedures, observe the following 
important safety and handling rules to avoid damage to yourself and the equipment:
To protect users from electric shock, ensure that the power supplies for each VP, 
VPx and Control Panel connect to earth via the ground wire provided in the AC 
power Cord.
The AC Socket-outlet should be installed near the equipment and be easily 
accessible.
råé~ÅâáåÖ=~åÇ=fåëéÉÅíáçå=
Before opening the boxes, inspect them for damage.  If you find any damage, notify the 
shipping carrier immediately for all claims adjustments.  As you open each box, compare its 
contents against the packing slips.  If you find any shortages, contact your Barco sales 
representative. 
Once you have removed all the components from their packaging and checked that all the 
listed components are present, visually inspect each Controller and Processor to ensure 
there was no damage during shipping.  If there is damage, notify the shipping carrier 
immediately for all claims adjustments.
páíÉ=mêÉé~ê~íáçå=
The environment in which you install your Encore Presentation System should be clean, 
properly lit, free from static, and have adequate power, ventilation, and space for all 
components. 
o~ÅâJjçìåí=fåëí~ää~íáçå
Encore VP and VPx units are designed to be rack mounted, and are supplied with front 
rack-mount hardware.  Rear rack-mount brackets are available as a kit, and are 
recommended when units are mounted in transit cases. 
When rack mounting VP and VPx units, remember the following important points:
Maximum ambient operating temperature for the unit is 40 degrees C. 
Leave at least one inch of space (front and rear) to ensure that the airflow through 
the fan and vent holes is not restricted. 
Distribute the units evenly to prevent hazardous conditions that may be created by 
uneven weight distribution. 
Rack mount the units from the front rack ears using four rack screws (not 
supplied).  Threads may be metric or otherwise — depending upon the rack type.  
Install the lower of the two mounting holes first.