Barco Projector 26-0313000-00 Benutzerhandbuch
Encore Presentation System • User’s Guide • Rev 04
65
3. Hardware Installation
Installation
páåÖäÉ=pÅêÉÉå=`çåÑáÖìê~íáçå
The figure below illustrates a block diagram of a single screen Encore configuration. Use
this diagram for reference in the following procedure. Please note:
this diagram for reference in the following procedure. Please note:
•
Aux destinations are not shown in the diagram below.
Figure 3-1. Block Diagram, Single Screen Encore Configuration
For this configuration, you will need:
Use the following steps to install a single screen Encore configuration:
1.
Follow the unpacking procedures as listed in the “
section on page 62.
Scaled
Sources
Unscaled
Sources
Controller SC or LC
PG 2
PVW
PG 1
M/E Inputs
Ethernet Switch
Projector
Program
Preview
Encore Video Processor
To:
Routers
ScreenPRO-II
PresentationPRO-II
ImagePRO
Table 3-2. Equipment List, Single Screen Encore Configuration
Qty.
Item
Note
1
VP
VPx cannot be used
1
Controller
Model LC or SC
1
Video Projector
Customer supplied
2
DVI or Analog Monitors
Program and Preview (customer supplied)
1
Ethernet Switch
Customer supplied
2
Ethernet cables
Customer supplied. Additional cables required for routers.
TBD
Sources, routers, cables
Analog, Video and/or DVI as required (customer supplied)