Barco Projector 26-0313000-00 Benutzerhandbuch

Installation

— connect DVI outputs from processors one, two and three 

to processor #4’s scaler inputs:

Connect processor #1 DVI Program 2 output to processor #4 input 1A. 

Connect processor #1 DVI Preview 2 output to processor #4 input 1B. 

Connect processor #2 DVI Program 2 output to processor #4 input 2A. 

Connect processor #2 DVI Preview 2 output to processor #4 input 2B. 

Connect processor #3 DVI Program 2 output to processor #4 input 3A. 

Connect processor #3 DVI Preview 2 output to processor #4 input 3B. 

 — 

Connect processor #4’s analog or digital Preview Output to the input of 
your widescreen preview monitor.

(Optional, for video recording) Connect processor #4’s analog or digital 
Program Output 1

 or 2 to the input of the ImagePRO.  Connect the 

ImagePRO’s output to the input of your recorder.  Refer to the 
“ImagePRO User’s Guide” for connection and setup details.

 — connect AC power cords to the AC Power connectors on 

the rear of processor #4, the monitor and the ImagePRO. 

 — Using the Unit ID Selector, set the ID of processor #4 to 4.  

 — all power on instructions are covered in Chapter 6.

With all connections made, continue with Chapter 4, “

” on 

Once you are familiar with the Controller, all system setup procedures and basic Encore 
operations, you must complete the following operational setup steps — in order to properly 
configure processor #4 and its Preview output.  

„

 — Use the following steps to complete your wide screen 

preview setup, using six individual buttons for processor sources:

Set up processor #4 as a unique Encore destination.  In Chapter 6, refer to the 
“

” section on page 277.

On the Controller, identify six buttons on the Source Selection Bus that you want 
to use as the inputs from processors 1, 2 and 3.  

Set up these designated inputs as direct DVI connections.  In Chapter 6, refer to 
the “

” section on page 293 for details.

Program 2 output is used because it is a clean feed, without 
any edge feathering or data doubling in the signal.

Each processor must have a unique ID.

Two different methods are available for connecting processor 
sources:  multi-button and single button.