Boxlight 12SF Benutzerhandbuch
24
Displaying your Computer Source
NOTE: Always use the power cord
that shipped with the projector.
1
Remove the lens cap.
2
Plug the power cord into the side of the projector, then plug it
into your electrical outlet. A surge-protected power strip is
recommended.
into your electrical outlet. A surge-protected power strip is
recommended.
•
The LED on the top of the projector (Figure 24 on page 30)
lights green.
lights green.
3
Turn on the lamp by pressing the green
power
button on the
keypad or remote.
•
A tone sounds when you press the button, and the LED
blinks green while the software initializes. When initializa-
tion is complete, the LED lights solid green and the startup
screen appears.
blinks green while the software initializes. When initializa-
tion is complete, the LED lights solid green and the startup
screen appears.
4
Turn on your computer.
a
The first time you connect a particular computer to the pro-
jector, the computer recognizes the projector as “new hard-
ware” and the Add New Hardware Wizard appears.
Follow these instructions to use the Wizard to load the cor-
rect driver (which was installed with your Windows oper-
ating system).
jector, the computer recognizes the projector as “new hard-
ware” and the Add New Hardware Wizard appears.
Follow these instructions to use the Wizard to load the cor-
rect driver (which was installed with your Windows oper-
ating system).
Click Next. Make sure “Search for the best driver” is selected,
then click Next.
then click Next.