Bosch Appliances Radio LE10 Benutzerhandbuch

Seite von 24
LE10 Radio Receiver
Installation | en
9
Bosch Security Systems
User Manual
F.01U.278.517 | V2.0 | 2012.11
3
Installation
3.1
Unpacking
The LE10 Radio Receiver is carefully packed for transportation. 
The components contained in the box are protected, but should 
be handled with care. Store the packaging material for further 
use (storage or transport). In case of defective or missing 
equipment, do not try to install the LE10 Radio Receiver.
Contact immediately your local representative.
1. Take all components out of the box and place the LE10 Radio 
Receiver on the working space.
2. Check that the following accessories are delivered: the 
fixings (2 screws and 2 screw anchors) and this user manual.
3. Check that the LE10 Radio Receiver and its accessories have 
not been damaged during transportation.
3.2
Connecting the power supply
There are two different ways to connect the power supply of 
the LE10 Radio Receiver. After connection, the LE10 Radio 
Receiver will be in standby mode.
3.2.1
Power supply with the RJ12 power socket
The LE10 Radio Receiver can be powered by a power supply 
unit (PSU). The PSU should be plugged in the RJ12 socket on 
the rear side of the unit and should be easily accessible at any 
time. See Section 4.1 Connecting ports, page 11 for access to 
information about the power supply.
3.2.2
Power supply connected to a wired installation
The LE10 Radio Receiver can be powered by connecting a wired 
input into poles 1 and 2 of the connection board. See 
power supply.