Bil-Jax Wheelchair XLB-4232 DC Benutzerhandbuch

Perform the following procedures to operate the XLB-4232 DC Boom Lift. 

1.  Read and follow all safety precautions contained in Section 1 and all 

responsibilities outlined in the ANSI A92.2 reprint contained in Section 7 of this 
manual. 

2.  Position the lift at the work area. Make sure the lift is on a firm and level surface 

and that there are no potential hazards such as overhead obstructions or 
electrically charged conductors. Do not operate the lift if such hazards exist. 

3.  Check the tow trailer and boom lift for damaged or worn parts. Repair or replace 

parts as necessary. Do not use a damaged boom lift. 

4.  Lower the trailer tongue jack and unhitch the trailer from the tow vehicle. The 

trailer must be unhitched before the outriggers are deployed. 

5.  Deploy the boom lift outriggers as follows: 

a.  Lift up on the locking pin and slide each outrigger out from the trailer frame. 

Slide the outriggers out until the locking pins engage again. 

b.  Pull out the quick-adjust jack pins and lower the jack feet. With the jack feet 

near the ground, reinstall the jack pins at the lowest available setting.  

c.  Turn the BATTERY  ON/OFF switch to the ON position. Lift the bubble 

level cover plate in front of the boom rotation housing (slew ring housing). 

d.  Jack up the outriggers to evenly raise the trailer; refer to the bubble level. 

Raise the boom lift evenly until at least one trailer wheel is off the ground 
and all outrigger LED’s are lit. 

e.  Flip outrigger jack handles over to keep them from being damaged by 

falling objects or bent by lowering the boom onto them.  

6.  Remove the pin keeper and transport pin that secures the boom to the trailer 

frame. Stow the transport pin in its storage tube. 

7.  Unlock and open the base controls door. 

8.  Toggle the UPPER/OFF/LOWER controls switch to the LOWER position. 

9.  Use the lower control panel to operate the lift controls. Raise, lower, extend, and 

rotate the boom in slow speed to get familiar with the controls. Learn to 
smoothly start and stop the boom lift. 

10.  To place the basket at an easier entry height: 

a.  Raise the boom clear of its support post by holding the controls selector 

switch to LOWER position and also activating the UP function. 

b.  Rotate the boom clockwise from its transport position by holding the 

controls selector switch to LOWER position and also activate CW function. 
Rotate until there is clearance between the support post and the boom. 

c.  Lower the boom until the basket just touches the ground by holding the 

controls selector switch to LOWER position and also activate the DOWN 
function. 

11.  Switch the controls selector switch to UPPER controls. Control of the boom is 

now directed to the basket control panel.