Bad Boy Mowers BAD BOY 02.9812.0001C Benutzerhandbuch

The Bad Boy™ Spot Luminaire requires standard AC power distribution from 200-240 VAC, 50/60 
Hz, 15A maximum. The upper enclosure provides a Neutrik® connector for power input. Use the 
provided AC Line Cord Cable Assembly (25.9812.0902.5) to connect power.

Refer to 

on page 83 for details on power consumption at 

various voltages.

The Bad Boy Luminaire is equipped with two, 5-pin XLR connectors for DMX IN and DMX THRU 
(out) applications. DMX IN requires a 5-pin, female XLR connector and DMX THRU requires a 5-
pin, male XLR connector. When purchasing or constructing data cables, it is important that not only 
the correct cable type be used, but also quality cable to ensure a reliable DMX512 system. Your 
cabling should meet the following USITT DMX specification requirements:
•

Suitable for use with EIA485 (RS485) operation at 250k baud.

•

Characteristic impedance 85-150 ohms, nominally 120 ohms.

•

Low capacitance.

•

Two twisted pairs.

•

Foil and braid shielded.

•

24 AWG minimum gauge for runs up to 1000 feet (300m).

•

22 AWG minimum gauge for runs up to 1640 feet (500m).

Note:  Microphone type cables and other general purpose, two-core audio or signal cables are not 
suitable for use with DMX512.

CONFIG

addr

043

univ

A

1400w

LAMP

hrs

125

temp

34C

INFO

01:34

TEST

COMM

DMX

STATUS

OK

Neutrik® AC 
Power Connector