Bad Boy Mowers BAD BOY 02.9812.0001C Benutzerhandbuch

When AC power is applied, the luminaire will begin a calibration sequence which moves its pan, tilt, 
and all beam control mechanisms. After calibration, the luminaire head will either stop at its "home" 
position (which positions the pan axis at mid-rotation and the head parallel to the yoke with the lens 
pointing away from the luminaire upper enclosure) or move to its current DMX-defined position if 
DMX512 data is present. The beam control mechanisms will also move to their "home" or DMX-
defined positions. The lamp is set to OFF in the default mode. 
The luminaire also contains an on-board battery so that it can be addressed and configured without 
being connected to main power (refer to 

CAUTION:  Before applying power, be sure the luminaire is hung or positioned so that the head and 
yoke can move freely without restriction. Refer clearances in 

 on 

.

CAUTION:  If luminaire is operated without yoke leg covers in place, pan problems will occur.

To power up:
Step 1. At each luminaire, connect power. Allow luminaire to complete its calibration sequence.
Step 2. For normal power up, the Menu Touchscreen "Home" screen will display Status OK. The 

Home screen will also display the luminaire’s DMX address and lamp information.

Step 3. Check Comm LED for proper operation. Refer to 

Step 4. To strike lamp, send appropriate command from console or follow steps provided in 

on page 25.

Note:  Refer to 

on page 30 for more information about the Menu Touchscreen.