Bad Boy Mowers BAD BOY 02.9812.0001C Benutzerhandbuch

The zoom tables, which allow the fixture to maintain sharp focus on an image throughout the zoom 
range, are sensitive to the throw distance. For this reason, a variety of zoom table versions are available 
for use with different throws. The zoom table is selectable via control channel settings described in 

on page 41. The zoom table setting is persistent and will maintain its value 

through power cycles. The default setting is 30 feet.

The Gobo Set Zero command allows adjustment of the gobo wheel’s home position. When this 
command is issued, the luminaire sets the current wheel position as the "zero" position and stores this 
offset so it will be retained at the next startup. This allows correction for a sensor that may be slightly 
out of position causing the gobo wheel to not be perfectly centered and therefore obstructing part of the 
beam in the open position.
To set zero position:
Step 1. Using console, move wheel into desired center position.
Step 2. Execute Set Zero Position command (Control Channel DMX value 80). The luminaire will 

now remember the setting as the new zero position.

OUT OF ALIGNMENT

GOBO WHEEL #2

PROPERLY ALIGNED

GOBO WHEEL #1