Woods Equipment MZ2252K Benutzerhandbuch
34
WOODS
ADJUSTMENTS
DECK LEVELING
1. Park the machine on a smooth, level surface.
Raise the deck to the transport position.
2. Lower the deck onto a set of equal height blocks
A under the rear corners of the deck. Place an-
other set of blocks
B under the front of the deck
so that the deck top is pitched forward 1/8".
NOTE: The front and rear of the deck are at different
heights.
3. Measure the height of the blade cutting edge
3. Measure the height of the blade cutting edge
above the ground. Remove pin
C and set the
height of cut lever
D to that height.
4. Loosen nuts
I at all four corners of the deck.
NOTE: This will relieve tension on chains H.
5. Loosen the jam nuts
5. Loosen the jam nuts
E on the height of cut
clips
F and adjusting screws G. Turn the adjust-
ing screws
G until the play is taken out of the
chains
H at all four corners. Tighten the jam nuts
E against the clips F and at the adjusting screws
G. Retighten nuts I at this time.
6.
COUNTERBALANCE SPRINGS
a) Raise the cutterdeck all the way.
b) Adjust the spring
b) Adjust the spring
A with nut B:
Approximately 1" of threads should be extending
past the spring mounting bracket at nut
B.
The springs may be tightened or loosened from
this point according to personal preference.