Whirlpool Roper FEP310KV3 Benutzerhandbuch

Seite von 16
14
Storage Drawer
The storage drawer can be removed. Before removing, make sure 
drawer is cool and empty.
To Remove:
1. Pull the storage drawer straight back past the drawer stop 
notch and the end of the side rails.
2. Lift up the back of the drawer and pull the drawer out.
To Replace:
1. Lift up the back of the drawer and place it inside the range in 
its fully forward position.
2. Lift up the front of the drawer to a level position.
3. Slowly push the drawer into the range until the drawer side 
rails engage with the gap in the drawer glides.
4. Once the drawer is fully engaged on both sides, slide the 
drawer back into the closed position. 
NOTE: When removing and replacing the storage drawer, a 
slight push may be needed to move the drawer stop notch 
past the drawer glides.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
Nothing will operate
Is the power supply cord unplugged?
Plug into a grounded outlet.
Has a household fuse blown, or has a circuit breaker 
tripped?
Replace the fuse or reset the circuit breaker. If the problem 
continues, call an electrician.
Cooktop will not operate
Is the control knob set correctly?
Push in knob before turning to a setting.
On ceramic glass models, is the “Cooktop Lockout” set?
See “Cooktop Lockout” section.
On coil element models, is the element inserted properly?
See “Coil Elements and Burner Bowls” section.
Excessive heat around cookware on cooktop
Is the cookware the proper size?
Use cookware about the same size as the surface cooking 
area, element or surface burner. Cookware should not extend 
more than ½" (1.3 cm) outside the cooking area.
Hot Surface indicator light stays on
Does the Hot Surface indicator light stay on after control 
knob(s) have been turned off?
See “Cooktop Controls” section.
Cooktop cooking results not what expected
Is the proper cookware being used?
See “Cookware” section.
Is the control knob set to the proper heat level?
See “Cooktop Controls” section.
Is the appliance level?
Level the appliance. See the Installation Instructions.
On coil element models, is the element inserted properly?
See “Coil Elements and Burner Bowls” section.
Oven will not operate
On some models, is the electronic clock/timer set 
correctly?
See “Electronic Clock/Timer” section.
On some models, has the oven selector been set to a 
BAKE or BROIL function?
See “Baking and Roasting” or “Broiling” sections.
Oven temperature too high or too low
Does the oven temperature calibration need adjustment?
See “Oven Temperature Control” section.
Oven indicator lights flash
Do the OVEN HEATING indicator lights flash?
See “Assistance or Service” section.
A. Drawer stop notch
B. End of side rail
A
B
A. Engage drawer glide
A