Whirlpool 9762363A Benutzerhandbuch

4. Once the drawer is fully engaged on both sides, slide the 

drawer back into the closed position. A slight push may be 
needed to move the drawer stop notch past the drawer 
glides.

Remove all items from inside the warming drawer, and allow the 
unit to cool completely before attempting to remove the drawer.

1. Open drawer to its full open position.

2. Locate the black triangle-shaped tabs on both sides of the 

drawer.

3. Press the tab down on the right side, and lift tab up on the left 

side at the same time, then pull drawer out another inch.

4. Holding the drawer by its sides, slowly pull it all the way out.

1. Align the drawer glides with the receiving guides.

2. Push drawer in all the way.

3. Gently open and close the drawer to ensure it is seated 

properly on the slides.

■

Is the power supply cord unplugged?
Plug into a grounded 3 prong outlet.

■

Household fuse blown or circuit breaker tripped?
Replace the fuse or reset the circuit breaker. If the problem 
continues, call an electrician.

■

Is this the first time the surface burners have been used?    
Turn on any one of the surface burner knobs to release air 
from the gas lines.

■

Is the control knob set correctly?
Push in knob before turning to a setting.

■

Are the burner ports clogged?
See “Sealed Surface Burners” section.

■

Are the burner ports clogged? 
See “Sealed Surface Burners” section.

■

On models with caps, are the burner caps positioned 
properly?
See “Sealed Surface Burners” section.

■

Is propane gas being used?
The appliance may have been converted improperly.    
Contact a service technician or see “Assistance or Service” 
section.

■

Is the burner wet?
Let it dry.

■

Is the cookware the proper size?
Use cookware about the same size as the surface cooking 
area, element or surface burner. Cookware should not extend 
more than ½" (1.3 cm) outside the cooking area.

■

Is the proper cookware being used?
See “Cookware” section.

■

Is the control knob set to the proper heat level?
See “Cooktop Controls” section.

■

Is the appliance level?
Level the appliance. See the Installation Instructions.

■

Is this the first time the oven has been used?
Turn on any one of the surface burner knobs to release air 
from the gas lines.

■

Is the electronic oven control set correctly?
See “Electronic Oven Controls” section.

■

On some models, is the Control Lock set?
See “Control Lock” section.

■

Is propane gas being used?
The appliance may have been converted improperly. Contact 
a service technician or see “Assistance or Service” section.

■

It is normal for the fan to automatically run while the oven is in 
use to cool the electronic control.

A