West Elm Wave Shelf Montageanweisungen
mounting instructions
: wave shelf
8385056- 08/05
page 1 of 1
drywall anchor 6x
screw 6x
A
B
NOTE:
• Stud mounting is recommended. Use proper hardware
for your wall type (such as anchors for drywall). When
in doubt, consult your local hardware store. For your
safety, installation by two people is recommended.
for your wall type (such as anchors for drywall). When
in doubt, consult your local hardware store. For your
safety, installation by two people is recommended.
• This shelf can be mounted either way horizontally.
• Designed to be used for decorative items only.
•
Maximum load per shelf is: 24 lbs.
• Wipe with a soft, dry cloth. To protect the finish, avoid
the use of all chemicals and household cleaners.
the use of all chemicals and household cleaners.
1
2
2
2
6
2
1. Hold shelf at desired location. With a pencil, mark on wall the top
outside corners of the shelf. These marks will be used to determine
the location of the mounting hardware.
outside corners of the shelf. These marks will be used to determine
the location of the mounting hardware.
2. Measure down from the top of the shelf to the top of the keyhole
notches. Measure in from the side of the shelf to the top of the
keyhole notches. Record these measurements on the wall, using the
marks in step 1 as a guide. Align the two measurements until they
intersect. This is the insertion point of the mounting hardware. Use
a carpenter's level to ensure the shelf will be level.
notches. Measure in from the side of the shelf to the top of the
keyhole notches. Record these measurements on the wall, using the
marks in step 1 as a guide. Align the two measurements until they
intersect. This is the insertion point of the mounting hardware. Use
a carpenter's level to ensure the shelf will be level.
3. For stud mounting: skip to step 4. For drywall mounting: using a
Philip's head screwdriver, insert the drywall anchors (A) into the
wall at the insertion points. Press and turn clockwise until anchors
are flush with the wall.
Philip's head screwdriver, insert the drywall anchors (A) into the
wall at the insertion points. Press and turn clockwise until anchors
are flush with the wall.
4. Insert screws (B) into the anchors or at the insertion points, l
eaving
approximately 1/2" between the back of the screw head and the wall.
5. Align keyhole notches over the screw heads.
6. Slide the shelf down until it rests on the screws. Tighten or loosen
screws as needed to fit the shelf snugly against the wall.
screws as needed to fit the shelf snugly against the wall.
!
For drywall mounting, use anchors with screws.
For stud mounting, use screws only.
3-5
A
B