West Elm Flat Stock Metal Double Sconce Montageanweisungen
page 1 of 2
assembly instructions
flat stock metal double sconce
60-watt TYPE B standard bulbs (not included). To avoid the risk of
Important Safety Instructions:
•
•
These instructions are provided for your safety. It is important that they are read carefully and completely before
installing the chandelier.
•
We strongly recommend that a professional electrician install all direct wire fixtures.
•
This fixture has been rated for up to (2)
fire, do not exceed the recommended wattage.
Pre-assembly:
•
•
Remove all parts and hardware from box along with any plastic packaging. Do not discard any
contents until after assembly is complete to avoid accidentally discarding small parts or hardware.
•
For your safety and convenience, assembly by two people is recommended.
Parts Enclosed:
•
(1) Mounting plate (J)
•
(1) Canopy (I)
•
(2) Socket Ring (F)
•
(2) Metal Tube (G)
•
(1) Metal plate (K)
•
(2) Glass Shade (H)
IT IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE
To Assemble:
1. SHUT OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT BREAKER.
2. Carefully unpack all fixture parts and hardware and lay out on a clear workspace.
3. Carefully inspect the fixture wires. The NEUTRAL FIXTURE WIRE is white. The HOT FIXTURE
2. Carefully unpack all fixture parts and hardware and lay out on a clear workspace.
3. Carefully inspect the fixture wires. The NEUTRAL FIXTURE WIRE is white. The HOT FIXTURE
WIRE is black. The bare wire is the GROUND WIRE.
4. Attach the GROUND WIRE from the fixture to the GROUND JUNCTION BOX WIRE from the outlet (usually
green or bare wire). Fasten each together with a plastic wire connector (A) and wrap the connection with
electrical tape. Be sure that no wire strands are exposed. If your outlet box DOES NOT have a GROUND WIRE,
be sure to insert the green ground screw (B) into the mounting plate (J) as shown, and wrap the fixture's
bare ground wire around the ground screw.
PROPERLY GROUNDED.
electrical tape. Be sure that no wire strands are exposed. If your outlet box DOES NOT have a GROUND WIRE,
be sure to insert the green ground screw (B) into the mounting plate (J) as shown, and wrap the fixture's
bare ground wire around the ground screw.
PROPERLY GROUNDED.
5. Connect the NEUTRAL FIXTURE WIRE to the NEUTRAL JUNCTION BOX WIRE ( white). Fasten each together
with a plastic wire connector (A) and wrap the connection with electrical tape. Be sure no wire strands are
exposed.
exposed.
Hardware Included:
•
•
Mounting screws (D)
•
Green ground screw (B)
•
Plastic wire connectors (A)
•
Canopy screws (C)
•
Wrench (E)
To install you will need:
•
•
Electrical tape
•
Screwdriver
9157959 - 01/07
F
G
H
I
A
B
D
C
I
K
H
J
C
E
F
G
A
B
C
D
E
wire cap 3x
grounding screw 1x
canopy screw 4x
mounting screw 2x
wrench 1x