West Elm Branch Mirror Montageanweisungen

branch mirror

mounting instructions

Page 1 of 1

9566464/9566514/8395592 - 04.03.08

CARE INSTRUCTIONS
 

Hardware may loosen overtime. Periodically check that all connections are tight.

 

Wipe with a soft, dry cloth. To protect fi nish, avoid the use of chemicals and household cleaners.

NOTE: Stud mounting recommended. 

1

2

2

2

6

2

drywall anchor    2x

screw    2x

A

B

1.    Hold mirror at desired location. With a pencil, mark on wall the top

       outside corners of the mirror. These marks will be used to determine

       the location of the mounting hardware.

2.    Measure down from the top of the mirror to the top of the D ring .

       Measure in from the side of the mirror to the top of th e

       D ring.  Record these measurements on the wall, using the

       marks in step 1 as a guide. Align the two measurements until they

       intersect. This is the insertion point of the mounting hardware. Use

       a carpenter's level to ensure the mirror will be level.

3.    For stud mounting: skip to step 4. For drywall mounting: using a

       Philip's head screwdriver, insert the drywall anchors (A) into the

       wall at the insertion points. Press and turn clockwise until anchors

       are flush with the wall.

4.    Insert screws (B) into the anchors or at the inse rtion points, leaving

       approximately 1/2" between the back of the screw head and the wall . 

5.    Align D ring over the screw heads.

6.    Slide the mirror down until it rests on the screws. Tighten or loosen

       screws as needed to fit the mirror snugly against the wall .

!

  For drywall mounting, use anchors with screws.

   For stud mounting, use screws only.

3-5

A

B

Use proper hardware for your wall type. For
drywall mounting we reccommend using hollow
wall anchors (#6-32) and 2” metal screws. When
in doubt, consult your local hardware store.
For your safety, assembly by two people is
strongly recommended.