Wayne-Dalton TORQUEMASTER PLUS 9300 Benutzerhandbuch
Tools Needed:
8
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Horizontal Angle
Hammer
Attaching Fully Adjustable Flagangle
to Vertical Track
NOTE: If quick install flagangles were installed in
Step 1, skip this step and continue with Step 3.
Step 1, skip this step and continue with Step 3.
Hand tighten the flagangle to the vertical track
using (1) stud plate and (2) 1/4” - 20 flange hex
nuts. Repeat for other side.
using (1) stud plate and (2) 1/4” - 20 flange hex
nuts. Repeat for other side.
Secure the flange nuts after flagangle spacing is
complete (Step 10).
complete (Step 10).
None
2
3
Position the horizontal angle as shown.
Place tabs of horizontal angle in the key slot of
horizontal track. Using a hammer, tap the horizontal
angle towards the curved end of the track until the
holes in track and angle are aligned. Repeat for
opposite side. Set tracks aside.
horizontal track. Using a hammer, tap the horizontal
angle towards the curved end of the track until the
holes in track and angle are aligned. Repeat for
opposite side. Set tracks aside.
NOTE: For larger doors, a full length horizontal angle
may be spot welded to the horizontal track. If the
horizontal angle is not welded, the horizontal angle
must be installed as shown.
may be spot welded to the horizontal track. If the
horizontal angle is not welded, the horizontal angle
must be installed as shown.
(2) 1/4”- 20 Flange
hex nuts
hex nuts
Fully adjustable
flagangle
flagangle
Vertical track
Stud plate
Horizontal angle
Hole
Tabs
Key hole slot
Horizontal track
Hole
Horizontal angle
Horizontal track
Horizontal angle
Horizontal track
Tabs