Woodstock W1819/W1820 Benutzerhandbuch

-73-

The miter gauge can be adjusted so it is perpendicular to 
the blade and so it is snug in the T-slot.

90° Square .......................................................1
45° Square .......................................................1
Hex Wrench 2.5mm .............................................1
Hex Wrench 2mm ...............................................1
Hex Wrench 3mm ...............................................1

(%  DISCONNECT THE SAW FROM POWER!

)%  Slide the miter gauge into the T-slot on the table.

*%  Loosen the miter gauge lock knob, pull out the 

positive stop knob, then pivot the miter gauge body 
to 90° so the stop knob springs into position.

=`^li\('0% Checking 90° stop on miter 

gauge.

JhlXi\

D`k\i>Xl^\

9cX[\

=`^li\(('% Screws for adjusting miter 

gauge body.

Button Head 

Cap Screws

Positive 

Stop Knob

,%  Loosen the button head cap screws on the positive 

stop knob block (see 

=`^li\ (('), adjust the miter 

body until it is flush with the square, then tighten the 
screws.

-%  Loosen the screw on the front of the miter bar, adjust 

the pointer to 0°, then tighten the screw.

+%  Place the 90° square evenly against the face of the 

miter gauge and the blade, as shown in 

=`^li\('0. 

— If the square touches the miter body and the body 

of the blade (not the teeth) evenly at the same 
time, then it is square to the blade and the 90° 
stop is set correctly. No further adjustments are 
necessary.

— If the square does not touch the miter body and 

blade body evenly at the same time, then proceed 
to 

Jk\g,.

The miter bar can be adjusted so it fits more tightly in 
the miter slot. 

To adjust the miter bar tightness, loosen the cap screw 
on each guide block (see 

=`^li\(((), adjust the set 

screws as needed, then tighten the cap screw.

=`^li\(((% Screws for adjusting miter bar 

in miter slot.

Set Screws

Cap Screws

Guide 

Block