Woods Equipment 8100 Benutzerhandbuch
25
PN-51210 (Rev. 7/98)
Problem
1. Rotor does not turn
2. Hard to feed chipper
or excessive power
needed to chip
3. Chipper requires
excessive power or
stalls
4. Drive belts
squealing or
smoking
5. PTO will not turn or
has slow RPM's
6. Vibration while
running
Suggested
Remedies
a) Use branch or
similar object to
clear discharge.
b) Clear rotor.
a) Use branch or
similar object to
clear discharge.
b) Sharpen blades.
c) Adjust clearance.
a) Use branch or
similar object to
clear discharge.
b) Clear rotor, feed
material into
shredder more
slowly.
c) Alternately feed dry
material, or allow
material to dry.
a) Clear rotor.
b) Adjust belt tension
or replace belts if
needed.
a) Engage PTO.
b) Check all
connections and
repair if needed.
a) Check drive belts
and pulleys for bad
or worn spots.
Check PTO shaft for
wear.
b) Inspect rotor for
broken or missing
chipper blades and
paddles. Repair if
needed.
c) Check rotor to see if
it wobbles.
d) Check to see if rotor
is assembled
correctly.
Probable Cause
a) Obstructed
discharge.
b) Plugged rotor.
a) Obstructed
discharge.
b) Dull chipper blades.
c) Improper blade
clearance.
a) Obstructed
discharge.
b) Plugged rotor.
c) Green material will
not discharge.
a) Plugged rotor.
b) Loose or worn belts.
a) PTO shaft not
engaged on tractor.
b) PTO shaft loose.
a) Drive shaft vibration.
b) Rotor out of
balance.
Reference
Service and Maintenance
Service and Maintenance
Service and Maintenance
Service and Maintenance
Service and Maintenance
Service and Maintenance
Troubleshooting
T
R O U B L E S H O O T I N G