Whirlpool HD1000XSC7 Benutzerhandbuch

Caring For Your Hot Water Dispenser

1. Turn Temperature Control to 

the “Off” position. Push down and 
turn On/Off Cap clockwise and 
run water until it is cold to avoid 
possibility of burn.

2. Remove the two spout screws.

3. Remove spout base plate.

4. Pull the screen assembly out of 

the hot water tube.

5. Use a small brush and vinegar to 

remove hard-water deposit.

If deposit has hardened, soak in 
vinegar for an hour or two. Then 
use a brush to clean.

6. Replace screen assembly in tube.

Reattach plate back onto spout.

7. Turn Temperature Control to the

“Max” setting. The dispenser will 
be ready in about 15 minutes.

Cleaning the spout screen

If you have very hard water, and you
notice that the water flow is reduced,

it may be necessary to clean the
spout screen.

Energy-saving tips and preparation for periods of
nonuse

On average, you will use your hot
water dispenser to heat 7 to 8 cups
of water per day. This uses only 19
kilowatt-hours of energy per month.
So it is Not necessary to turn off the
hot water dispenser each night to
conserve energy.

However, if the hot water dispenser
will not be used for an extended
period of time, follow these
instructions:

Set the Temperature Control to the
“Off” position to conserve energy.

For short periods (2-30 days of nonuse):

For long periods of
nonuse (winterizing,
seasonal storage or
protection from freezing):

1. Turn Temperature Control to the 

“Off” position.

2. Unplug hot water dispenser power

supply cord.

3. Turn On/Off Cap, hold and run 

water until water is cold.

4. Turn saddle valve handle 

clockwise to turn off water supply.

5. Place a 3-quart minimum 

container under the drain plug at 
the bottom of the tank.

6. Use a screwdriver to remove the 

screw and O-ring from the drain 
tube.

7. Replace the screw and O-ring in 

the drain tube opening. Tighten 
the screw to reseal the drain.