Whirlpool W10432289A Benutzeranleitung

The storage drawer can be removed. Before removing, make sure 
drawer is cool and empty.

1. Pull storage drawer out to the first stop position.

2. Lift up the front of the drawer and pull the drawer out to the 

second stop position.

3. Grasp sides and lift drawer top up and out.

1. Fit the ends of the drawer glides into the rails in the range.

2. Lift up the front of the drawer and gently push in to the first 

stop position.

3. Lift drawer up again and push until drawer is closed.

For normal range use, it is not suggested to remove the oven 
door. However, if removal is necessary, make sure the oven is off 
and cool. Then, follow these instructions. The oven door is heavy.

1. Open oven door to the first stop position (opened about 

4" [10.0 cm]).

2. Grasp door at each side. Do not use the door handle to lift 

door.

3. Lift up evenly until door clears hinge arms.

1. Grasp door at each side.

2. Align slots in the door with the hinge arms on the range.

3. Slide the door down onto the hinge arms until the door is 

completely seated on the hinges. Push down on the top 
corners of the door to completely seat door on hinges. Door 
should not appear crooked.

■

Is the power supply cord unplugged?
Plug into a grounded 3 prong outlet.

■

Household fuse blown or circuit breaker tripped?
Replace the fuse or reset the circuit breaker. If the problem 
continues, call an electrician.

■

Is the main or regulator gas shutoff valve in the off 
position?
See Installation Instructions.

■

Is the range properly connected to the gas supply?
Contact a trained repair specialist or see Installation 
Instructions.

■

Is this the first time the surface burners have been used?
Turn on any one of the surface burner knobs to release air 
from the gas lines.

■

Is the control knob set correctly?
Push in knob before turning to a setting.

■

Are the burner ports clogged?
See “Sealed Surface Burners” section.

■

Are the burner ports clogged? 
See “Sealed Surface Burners” section.

■

Are the burner caps positioned properly?
See “Sealed Surface Burners” section.

■

Is propane gas being used?
The range may have been converted improperly. Contact a 
service technician or see “Assistance or Service” section.

■

Is the burner wet?
Let it dry.