Whirlpool TMH14XM Benutzerhandbuch

Seite von 16
5
Electrical Requirements
Observe all governing codes and ordinances. A 120 Volt, 60 Hz, 
AC only, 15- or 20-amp fused electrical supply is required. (A 
time-delay fuse or circuit breaker is recommended.) It is 
recommended that a separate circuit serving only this appliance 
be provided.
PARTS AND FEATURES
This manual may cover several different models. The model you 
have purchased may have some or all of the features shown here. 
The appearance of your particular model may differ slightly from 
the illustrations in this manual.
Turntable
The turntable can rotate in either direction to help cook food 
more evenly. Do not operate the oven without the turntable in 
place. See “Assistance or Service” to reorder any of the parts.
To Install:
1. Remove tape from the hub.
2. Place the support on the oven cavity bottom.
3. Place the turntable on the support.
Fit the raised, curved lines in the center of the turntable 
bottom between the three spokes of the hub. The rollers on 
the support should fit inside the turntable bottom ridge.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Failure to follow these instructions can result in
death, fire, or electrical shock.
Do not use an extension cord.
Do not use an adapter.
Do not remove ground prong.
GROUNDING INSTRUCTIONS
■  
For all cord connected appliances:
 The microwave oven must be grounded. In the event 
 of an electrical short circuit, grounding reduces the 
 risk of electric shock by providing an escape wire for 
 the electric current. The microwave oven is equipped 
 with a cord having a grounding wire with a grounding 
 plug. The plug must be plugged into an outlet that is 
properly installed and grounded.
WARNING: 
Improper use of the grounding plug can 
result in a risk of electric shock. Consult a qualified 
electrician or serviceman if the grounding instructions 
are not completely understood, or if doubt exists as to 
whether the microwave oven is properly grounded. 
■  
For a permanently connected appliance:
 This appliance must be connected to a grounded, 
 metallic, permanent wiring system, or an equipment 
 grounding conductor should be run with the circuit 
 conductors and connected to the equipment 
 grounding terminal or lead on the appliance.
Do not use an extension cord. If the power supply cord 
is too short, have a qualified electrician or serviceman 
install an outlet near the microwave oven.
SAVE THESE  INSTRUCTIONS
This device complies with Part 18 of the FCC Rules.
1. Charcoal Filter
(behind Vent Grille)
2. Microwave Inlet Cover
3. Microwave Oven Light
4. Vent Grille
5. Metal Shielded Window
6. Model and Serial Number Plate
  7. Grease Filters 
  (shipped in oven cavity)
  8. Cooking Guide Label
  9. Cooktop Light
10. Control Panel
Parts and Features not shown
Turntable
1. Turntable
2. Hub
3. Support
4. Shaft
1
3
2
4
7
5
10
9
8
6
1
2
3
4