Westell Technologies Westell UltraLine 7400 Benutzerhandbuch

 

 

 

 

 

030-300381 Rev. A 

56 

January 2004 

 UltraLine Home DSL Router (Models 7400, 7401) 

 User Guide 

8.  Replace the addresses in the fields labeled IP address, Subnet Mask, Gateway, DNS Primary, and DNS 

Secondary with the addresses you obtained from your Internet service provider. 

 
9.  Click on the set VC button. 
 
10. Click on OK in the VC Configuration pop-up screen. 
 
11. Click on OK in the reset Router pop-up screen.  
 
After you complete the preceding steps, the Router will be reconfigured and your new settings will take effect. After 
the Router has been reset, confirm that you have a DSL sync and that your PPP session displays UP before 
continuing your Router’s configuration. 
 

 
The following settings will be displayed if you select Services from the Configuration menu. 
 
Westell has developed an extensive list of NAT services and you may select any service from this list. By selecting 
your specific NAT service and setting up a NAT profile, you will ensure that the appropriate ports on your Router 
are open and that the required application traffic can pass through your LAN. For a list of supported services, go to 
section 16 (NAT Services). 
 

 

 

 
Current Profile 

Displays the NAT (Network Address Translation) services that you have 
selected. 

Service Name 

Drop down selection menu of NAT (Network Address Translation) service you 
can select to configure you Router. 

UPNP Enable 

Factory Default = Disabled 
Enabling UPNP (Universal Plug and Play) allows automatic device discovery 
by your operating system.