Weider PRO 9450 SYSTEM WEEVSY3912 Benutzerhandbuch

Seite von 35
5
ASSEMBLY
1
8
11
51
27
1
4
3
1
51
5
1.
Before beginning, make sure that you have read
and understand the information in the box above.
Locate and open the parts bag labelled “FRAME
ASSEMBLY.”
Press two 2” Square Outer Caps (51) onto the
Stabiliser (5) in the indicated locations. Press a 2”
Square Inner Cap (27) into the end of the Base (4).
Insert six 5/16” x 2 1/2” Carriage Bolts (1) up through
the Stabiliser (5). Insert two 5/16” x 2 1/2” Carriage
Bolts up through the Base (4).
Attach the Base (4) to the Stabiliser (5) with two
5/16” x 2 3/4” Bolts (11), two 5/16” Washers (8), and
two 5/16” Nylon Locknuts (3). Do not tighten the
Nylon Locknuts yet.
Before beginning assembly, carefully read the
following information and instructions:
• Due to the many features of the weight system,
assembly will require several hours. By setting
aside plenty of time and by deciding to make the
task enjoyable, assembly will go smoothly. You
may want to assemble the weight system over a
couple of evenings.
• Assembly requires two people.
• Place all parts of the weight system in a cleared
area and remove the packing materials; do not
dispose of the packing materials until assembly is
completed. 
• Assembly is divided into four stages: 1) frame
assembly, 2) arm assembly,  3) cable assembly,
and 4) seat assembly. The hardware for each
stage is packaged separately. 
• Wait until you begin each assembly stage to open
the parts bag labelled for that assembly stage.
• As you assemble the weight system, be sure that
all parts are oriented as shown in the drawings.
• Tighten all parts as you assemble them, unless
instructed to do otherwise. 
• For help identifying the small parts used in 
assembly, use the PART IDENTIFICATION
CHART located in the centre of this manual.
Note: Some small parts may have been pre-
attached for shipping. If a part is not in the parts
bag, check to see if it has been pre-attached. 
THE FOLLOWING TOOLS (NOT INCLUDED) ARE
REQUIRED FOR ASSEMBLY:
• two adjustable wrenches
• one standard screwdriver
• one phillips screwdriver
• one rubber mallet
• lubricant, such as grease or petroleum jelly,
and soapy water will also be needed.
• Assembly will be more convenient if you have the
following tools: A socket set, a set of open-end or
closed-end wrenches, or a set of ratchet wrenches.
1
FRAME ASSEMBLY