Antares TASCAM TA-1VP Benutzerhandbuch

is flat and that positive correction is being applied. 

Conversely, the yellow LEDs indicate that the input is 

sharp and that negative correction is required.

i

Press this button to select the scale to be used as 

target pitches for correction.

o

Press this button to set Auto-Tune’s pitch correction 

speed.

p

Press this button to set the compressor’s ratio, 

threshold and makeup gain.

a

This meter lights to indicate the amount of gain 

reduction taking place.

s

When this button is lit, the Compressor/Gate module 

is active.
When it is not lit, the module is bypassed. Pressing the 

button toggles its state.

d

Press this button to set the compressor’s attack time.

f

Press this button to set the compressor’s release time.

g

Press this button to set the compressor’s knee 

characteristic.

h

Press this button to set the gate’s ratio and threshold.

j

This meter lights to indicate the amount of gain 

reduction taking place.

k

When this button is lit, the De-esser module is active. 

When it is not lit, the module is bypassed. Pressing the 

button toggles its state.

l

DE-ESS
Press this button to set the de-esser’s ratio and 

threshold.

;

Press this button to set the frequency of the de-esser’s 

highpass filter.

z

Press this button to set the de-esser’s attack time.

x

Press this button to set the de-esser’s release time.

c

When this button is lit, both EQ bands are active. When 

it is not lit, they are bypassed. Pressing the button 

toggles its state.

v

This meter displays the TA-1VP’s output level..

b

When this button is lit, double tracking is active. When 

it is not lit, it is bypassed. Pressing the button toggles 

its state.

n

Press this button to select the type of equalization and 

the parameter values for parametric EQ band #1.

m

Press this button to select the type and amount of 

automatic double tracking.

,

Press this button to select the type of equalization and 

the parameter values for parametric EQ band #2.

.

Press this button to adjust the TA-1VP’s output gain 

and/or to engage the main bypass.

While main bypass is engaged, no other controls will 

respond until bypass is disengaged.

/

+

This LED lights when Phantom power for the XLR MIC 

IN input has been turned on in the setup menu.

!

MIC IN
This XLR connector is where a microphone can be 

connected to the TA-1VP. The TA-1VP can supply 48V 

phantom power for condenser microphones (turned 

this on in the setup menu). Either the MIC IN or LINE 

 

input can be selected for processing, but not both 

at the same time.
Line level signals should be connected to the rear 

panel 1/4” LINE IN connector.

@

–

This is a latching push button to engage a 20 dB pad 

into the XLR Microphone signal path. This lets you use 

the TA-1VP with loud sources.