Vantec NBW-100U Benutzerhandbuch

NBW-100U 2.4GHz Wireless Presenter User’s Manual 

 

 

- 9 -

 

The laser pointer function is de-activated by default. To activate this function, press 

and hold the Laser key & Mode key simultaneously for about 3 seconds until the 

LED flashes red to confirm activation. To de-activate the laser point, just repeat 

these steps.   

 

+ 

 

= Activate / De-activate Laser Point Function 

When laser point is activated, you can press and hold the Laser Light key to shoot 

the laser light and release the key to turn it off. 

Note: If the batteries inside the presenter are replaced, you will need to re-activate 
the laser point function before you can use it.   

If your presenter is not working or RF interference with other remote device occurs, 

then you need to reset the ID shared by the presenter and the receiver so that they 

can establish a communication link. To reset the ID, make sure the receiver is 

plugged to a computer and take the steps below: 

1. Press 

the 

Mode key in conjunction with the Mouse Left key for about 3 

seconds until the LED flashes in green. Then release the keys. 

   

 

 

 

 

 

2.  Insert a pin or bent paperclip into the small hole on the receiver. Press it lightly 

and then release. 

3.  The reset is complete and now the presenter is ready to use. You can verify the 

link just using the mini stick to see if it controls the cursor.   

Note: As the laser point function is independent from the receiver, it cannot be 
used to verify the link. 

Press simultaneously 
until the LED flashes.