SonicWALL Webcam TZ 180 Benutzerhandbuch

Page 28

  Appendix B: Safety Instructions and Regulatory Information  

Appendix B: Safety Instructions and Regulatory 
Information

APL17-049

TZ 180 Wireless

•

Mount in a location away from direct 

sunlight and sources of heat. A maximum 

ambient temperature of 104º F (40º C) is 

recommended.

•

Route cables away from power lines, 

fluorescent lighting fixtures, and sources 

of noise such as radios, transmitters, and 

broadband amplifiers

•

The included power cord is intended for 

use in North America only. For European 

Union (EU) customers, a power cord is not 

included.

•

Ensure that no water or excessive 

moisture can enter the unit.

•

Allow unrestricted airflow around the unit 

and through the vents on the side of the 

unit. A minimum of 1 inch (25.44mm) 

clearance is recommended.

•

Consideration must be given to the 

connection of the equipment to the supply 

circuit and the effect of overloading the 

circuits has minimal impact on overcurrent 

protection and supply wiring. Appropriate 

consideration of equipment nameplate 

ratings must be used when addressing 

this concern.

The Lithium Battery used in the SonicWALL 

security appliance may not be replaced by the 

user. Return the SonicWALL security appliance 

to a SonicWALL-authorized service center for 

replacement with the same or equivalent type 

recommended by the manufacturer. If, for any 

reason, the battery or SonicWALL security 

appliance must be disposed of, do so following 

the battery manufacturer's instructions.

All Ethernet and RS232 (Console) cables are 

designed for intra-building connection to other 

equipment. Do not connect these ports directly 

to communication wiring or other wiring that 

exits the building where the SonicWALL is 

located. 

If the power supply is missing from your 

SonicWALL product package, please contact 

SonicWALL Technical Support at 408-752-7819 

for a replacement. This product should only be 

used with a UL listed power supply marked 

“Class 2” or “LPS”, with an output rated 12 VDC, 

minimum 1.66 A.