Sierra Wireless RAVEN 1X 20070914 Benutzerhandbuch
Global Positioning System (GPS)
Rev 3.0B Feb.08
96
Tip: If the PinPoint X is using a dynamic IP, *PPDEVID needs to be
enabled.
enabled.
Odometer Data in Reports
When the odometer report is enabled, the PinPoint X will
calculate distance between reports based on GPS data. The
modem’s odometer calculations can be included in the RAP
message.
calculate distance between reports based on GPS data. The
modem’s odometer calculations can be included in the RAP
message.
Figure 10-20: AceManager : PinPoint - *PPODOM, *PPODOMVAL
•
*PPODOM enables the odometer reporting.
•
*PPODOMVAL is the current odometer reading in the
PinPoint X. You can set this to a number to offset the
odometer calculation, such as one‐time manual synchroni‐
zation of the PinPoint X odometer with the current vehicle
odometer.
PinPoint X. You can set this to a number to offset the
odometer calculation, such as one‐time manual synchroni‐
zation of the PinPoint X odometer with the current vehicle
odometer.
Note: The odometer calculations of the PinPoint X may not match the
odometer in the vehicle itself. The PinPoint X odometer is not
connected to the vehicle’s, it is entirely based on calculations of GPS
readings.
odometer in the vehicle itself. The PinPoint X odometer is not
connected to the vehicle’s, it is entirely based on calculations of GPS
readings.
I/O Event Reports
You can configure the PinPoint X to send reports to the AVL
Host based on the state of the digital inputs.
Host based on the state of the digital inputs.
Tip: Setting up the I/O port hardware is covered in the Inputs, Relay
Outputs, and Power Status chapter.
Outputs, and Power Status chapter.
Enable *PPINPUTEVT to have events sent to the Host server.
Figure 10-21: AceManager : PinPoint - *PPINPUTEVT
COM 1000 support