Sierra Wireless RAVEN 1X 20070914 Benutzerhandbuch
Configuration Commands
Rev 3.0B Feb.08
119
*NETIP?
Note: If there is no current
network IP address, 0.0.0.0 may
be displayed.
network IP address, 0.0.0.0 may
be displayed.
The current IP address of the modem reported by the internal
module, generally obtained from AT&T. This is the address
can contact the PinPoint X from the Internet.
module, generally obtained from AT&T. This is the address
can contact the PinPoint X from the Internet.
Tip: Use *NETALLOWZEROIP if you need to allow the display of an
IP ending in a zero.
IP ending in a zero.
*NETOP?
The current cellular carrier from the modemʹs firmware
version, for example, AT&T.
version, for example, AT&T.
*NETRSSI?
The current RSSI (Receive Signal Strength Indicator) of the
PinPoint X as a negative dBm value.
PinPoint X as a negative dBm value.
Tip: The same information is displayed with the command S202?.
*NETSERV?
The type of service being used by the modem, for example
Tech.
Tech.
*NETSTATE?
The current network state:
•
Connecting To Network: The PinPoint X is in the process
of trying to connect to the cellular network.
of trying to connect to the cellular network.
•
Network Authentication Fail: Authentication to the
cellular network has failed. Verify settings to activate the
PinPoint X.
cellular network has failed. Verify settings to activate the
PinPoint X.
•
Data Connection Failed: The PinPoint X failed to connect,
and it is now waiting a set time interval before it attempts
to reconnect. Verify settings to activate the PinPoint X.
and it is now waiting a set time interval before it attempts
to reconnect. Verify settings to activate the PinPoint X.
•
Network Negotiation Fail: Network connection negoti‐
ation failed. This is usually temporary and often clears up
during a subsequent attempt.
ation failed. This is usually temporary and often clears up
during a subsequent attempt.
•
Network Ready: The PinPoint X is connected to the 1x
cellular network and ready to send data.
cellular network and ready to send data.
•
Network Dormant: The PinPoint Xis connected to the 1x
cellular network, but the link is dormant. It will be woken
up when data is sent or received.
cellular network, but the link is dormant. It will be woken
up when data is sent or received.
•
No Service: There is no cellular network detected.