Siemens AC75 Benutzerhandbuch

s

AC75_ATC_V01.002

Page 517 of 569

10/30/06

Confidential / Released

The 

 write command serves to configure the GPIO10 pin as pulse counter. The pulse counter is

designed to measure signals from 0 to 1000 pulses per second. 

Remember that if the GPIO10 line is configured as GPIO (see 

) any attempt to activate the pulse

counter will be rejected. Vice versa, if the pulse counter is opened the GPIO10 line cannot be configured as

GPIO.

 for further detail on the pulse counter. 

^SCCNT: 

The URC applies only to the Limit counter mode set with parameter 

=1. It is delivered once the pulse

counter has completed counting the number of pulses requested with parameter 

. 

0

Close pulse counter

1

Open pulse counter

Test Command

AT^SCCNT=?

Response(s)

^SCCNT:

(list of supported 

s), (list of supported 

s), (list of supported 

OK

Read Command

AT^SCCNT?

Response(s)

OK

ERROR

+CME ERROR: <err>

Write Command

Response(s)

OK

ERROR

+CME ERROR: <err>

Reference(s)

PIN

ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge

4

Last

SIEMENS

<action>

(num)