Schwinn 420 Benutzerhandbuch

•  Main Unit (from Step 3)
•  #19 - Console (Qty. 1)
•  #20 - Static Handlebar (Qty. 1)

•  #24 - M8 Flat Washer (Qty. 4)
•  #25 - M8 Lock Washer (Qty. 4) 
•  #30 - M8x20 Hex Screw (Qty. 4)
•  Pre-installed Screws in Back of Console (Qty. 4)

•   Phillips Head Screwdriver

4-1  Feed the Heart Rate Wire (W3) from the Static Handlebar 

through the rectangular opening in the handlebar.

4-2  Put the Console Mast Wire (W2) through the rectangular 

opening in the Static Handlebar. The Heart Rate Wire 

goes through the notch (N) in the Console Mast. Connect 

the Static Handlebar to the Console Mast with the 

hardware shown.

NOTICE:   Do not pinch the wires when putting the 

Static Handlebar on the Console Mast.

4-3  Remove the 4 pre-installed screws (S) in the back of the 

Console. Save them for Step 4-5.

4-4  Connect the Console Wire (W4) to the Console Mast 

Wire (W2). Connect the Heart Rate Wire to the Heart 

Rate connector (W5) from the back of the Console. 

4-5   Attach the Console

 

to the Static Handlebar assembly 

with the screws from Step 4-3.

NOTICE:   Do not pinch the wires when putting the 

Console on the Static Handlebar.

20

19

30

25

24

S

W5

W3

W2

W4

N