Toshiba Modem PCX1100U Benutzeranleitung

 

 

19 

To avoid thermal problems, allow at least one inch spacing between the ventilation 
holes and any object to either side of the unit. It's best to have no obstructions on 
top of  the unit. The top of the unit should be at least two inches from any 
obstruction.   
   
Connect the cable modem using the following steps, referring to the figure below. 
1.  Connect the Cable TV coax to the input connector of a signal splitter. 
2.  Connect a coaxial cable from one of the output connectors of the splitter to the 

input connector of the television set. 

3.  Connect a coaxial cable from the other output connector of the splitter to the 

RF input connector on the cable modem rear panel. 

4.  Connect the 10BASE-T and/or USB signal cable(s) from your computer(s) to 

the10BASE-T and/or USB connector(s) on the cable modem rear panel. 

5.  Connect the AC adapter to the DC IN 12V 1A jack on the cable modem rear 

panel. Then plug in the AC adapter to the wall electrical outlet. 

6.  If use the USB interface, Install the "USB Driver" following the instructions 

described in "Installing USB Drivers" on this manual. 

 

 
   
 
 
The power indicator LED on the modem front panel will light, if power is present at 
the outlet. The modem will start operating once power is connected. No additional 
operator intervention is required. It will automatically find the data channel, register 
and connect to your computer.   
Check the cable modem status. The front panel indicators (LEDs)  show that the 
cable modem is operating properly when they are in the following condition: 

POWER – lit 

CABLE - lit   

PC - lit 

DATA - flashing or not lit 

TEST - not lit 

Splitter 

AC Adapter 

Television 

10BASE-T 
Connection 

Cable 

Modem 

Cable TV 

Coax 

USB 
Connection