QMS 1800486-001C Benutzerhandbuch
6 & $
;
0 /
1
Remove the media cassette(s).
2
Pull out the jammed media.
3
Ensure that the media is lying flat in the cassette(s) and that it doesn’t
exceed the media limit mark.
exceed the media limit mark.
4
Slide the cassette(s) back into the printer.
4
4
WARNING!
The fuser unit is hot! Do not remove a jam in this area until the fuser unit
cools.
ACHTUNG!
Die Fixiereinheit wird sehr heiß! Bitte achten Sie darauf, daß sie diese
einige Zeit abkühlen lassen, bevor Sie einen Papierstau beseitigen.
Caution:
Media that hasn’t fully passed through the fuser contains unfused toner that
can dirty your hands, clothes, or any thing else it gets on. If you accidentally get toner
on your hands, wash them in cool water. If you accidentally get toner on your clothes,
lightly dust them off as much as possible. If some toner remains on your clothes, use
cool, not hot water, to rinse the toner off, provided your clothing is washable.
on your hands, wash them in cool water. If you accidentally get toner on your clothes,
lightly dust them off as much as possible. If some toner remains on your clothes, use
cool, not hot water, to rinse the toner off, provided your clothing is washable.
1
If you have a duplex model, see “Duplexer Jams” on page 7-9.
2
Open the rear cover of the printer.
»
Note:
The illustrations for steps 2
through 12 show the printer without
the duplexer. However, the
instructions are the same for both
models.
the duplexer. However, the
instructions are the same for both
models.
3
Remove the jammed media by
pulling it toward you.
pulling it toward you.
4
Close the printer’s rear cover.